Home      About us       Culture     Products       Feedback      Trade      Contact us
  YDW Series Low-noise
  YDW Series Low-noise
  DKF Serial Ventilator
  DDF Serial
  FS Serial Ventilators
  4-82 Serial Ventilators
  GW Serial Hot Fan
  PYF Serial Spouting
  WS-85-6 Serial Roof
  Structure and Model
  Winnow Fan
  Exhaust Fans
 
 
 >> YDW Series Low-noise Air-condition Fan:
  I) Characteristic:
   YDW Series Low-noise Air-condition Fan is a new kind of fan with high efficiency and adjustable running speed. It is made up of the advanced multi-wing impellers, logarithmic gyroidal-shaped shell, built-in low-noise auto motor with adjustable running speed, arc-shaped wind entrance etc. Both sides of the fan can absorb wind. They have the characteristics of small volume, strong wind and slight vibration. Auto motors can reduce pressure with the help of three-phase pressure-adjuster so as to adjust the speed as needed. Thus, they are suitable for the places with frequently changed wind speed. That's why they are the perfect fittings for air conditions, purifying machines, heating & aerating equipments, refrigerator and mobiles' drying-lacquer instruments.
  II) Structure:
  YDW Series Low-noise Air-conditioner Fan is made up of shell, impeller, wind entrance, auto motor, etc.
  1, The shell is made of the whole zinc-plating steel board and doesn't need to seal the joint. It is heat-resistant and wet-resistant with beautiful shape. And it can stands wear and tear.
  2, The impeller is the front-ward multi-wing arc-shaped vane riveted with front-pan and middle-pan. It's well done by using zinc-plating steel board. In order to guarantee the perfect precision, all the accessories of impeller are formed through punching treatment, then rectify them by static and dynamic balance after their combination. Thus, the impeller runs with slight vibration, excellent pneumatic capability, low noise and reliable performance.
  3, The wind entrance is made through the mould processing treatment. And its material is the zinc-plating steel. It's installed in both sides of fan. The section paralleling to the bearing is curve-shaped, which results in the fluent air transfer and little wastage.
  4, Auto motor: We use the outer-rotor three-phase asynchronous low-noise auto motor. The impeller is connected together with the auto motor by bolts, which result in the reduction of transfer wastage and the improvement of efficiency. With the help of three-phase pressure adjuster and converting-frequency speed adjuster, the running speed can be adjusted to meet the requirements of adjustable-wind volume.
  5, This series of fans have two types: "left-revolving" ones and "right-revolving" ones. According to the wire entrance, the clockwise revolving one is right-revolving, while the anticlockwise revolving on is left-revolving. The position of fan's exit can be made at the angle of 00C, 900C, 1800C, etc. You are highly appreciated if you can give us the clear indication when ordering.
  III) Uses
   1, It can be used in the buildings like factories, hotels, halls, hospitals, etc. It also can be used as the fittings of all kinds of central conditions, cabinet-shaped air condition sets, especially for the adjustable-wind low-noise air condition sets.
   2, It is suitable for matching every kind of purifying equipments.
   3, It can be used as the fittings of different kinds of purifying instruments.
   4, It can be used to transfer air for several kinds of mobiles' drying-lacquer studios and ovens.
  IV) Safety Precaution
   1, The medium that the fan transfers is the non-corrosive and non-volatile air without any sticky matter. Thus, the dust and hard granule should be no more than 120mg/m3.
   2, The shell should have the good ground connection.
   3, It's forbidden to run the fan fully-open. It should run within the limited voltage. Otherwise, it will result in the damage of the fan because of the overloaded power.
   4, The fan should have the auto motor protection equipment in order to perform safely.
   5, It's strictly forbidden to pull the electric line when you load, unload, transport or move fans; The parts of the fan can't be collided and extruded; It can't be placed where there is wet and corrosive.
   6, Please turn off the fan and cut off electricity supply when you hear some exceptional noise and find violent vibration. Then find out the reason and turn it on again after being repaired.
   7, You are sincerely hoped to tell us your requires about type, specification, flux, the complete pressure, running speed, the direction of wind entrance and left/right style when ordering the products.
   8, Please tell us when ordering the products if you have some special requires.
   9, We are sorry to not notifying everyone after the products have been modified.
  V)The Performance Parameter Form of YDW Series Low-noise Air-conditioner Fan
Type
4.5AS
4.5AL

4.5AL1

5.0A

6.0A

A

460

500

580

620

660

A1

490

530

610

650

690

A2
520
560

640

680

720

B

240

240

240

300

300

B1

270

270

270

330

330

B2

300

300

300

360

360

C1

490

530

610

660
700

C2

520
560
640
700
740
H

613

613

613

700
700
H1

313

313

313

366

366

H2

376

376

376

448

448

H3

657
657
657
755
755

H4

276

276

276

322

322

H5

654

654

654

785

785

F

612

612

612

700
700

F1

300

300

300

344

344

F2

653

653

653

785

785

L

500

500

500

515

515

L1

550

550

550

635

635

L2

500

500

500

615

615

L3

625

625

625

735

735

L4

500

500

500

515

515

L5

550

550

550

635

635

Φd

Φ11

Φ11

Φ11

Φ11

Φ11

 †)Click here to enter
 
 
                        Home | About us | News | Culture | Products | Feedback | Trade | Contact us
                        jiangsu Shuangju Fans Co Ltd.  Copyright  Tel:0515-88494999 88491145  Fax:0515-88494888